Publisher Profile

Emotiva Nostala LB12 three-way ported speakers Review

By: |

With subwoofers

Most speakers do not require subwoofers to perform as the manufacturer intended, and the LB12 does not require subwoofers. That does not mean it will not benefit from the addition of subs. Even large floor standing speakers with bass reaching below 30Hz are enhanced by subwoofers. As the Nostala LB12’s low frequency response is 40Hz +/-3dB, one of the first considerations to extend the performance is a pair of subwoofers, ideally active subwoofers with built in room correction and low frequency extension to below 20Hz +/-3dB.

Including the Perlisten D212s Subwoofers was a snap. Since they were tuned to my room when I reviewed them and the Perlisten S7t Towers, all I needed to do was adjust their low pass crossover point to 41 Hz and select an output level that matched the rest of the system. Now, the LB12’s bass was fully satisfying, both plump and clean, and thanks to the D212s units, the system had gravitas, and with plenteous impact.

Because of the additional low frequency energy produced by the subs, the midrange and treble seemed to shrink, to be anemic. Adding the 2dB to the output of these drivers through the contour switches on the back of the speaker restored balance across the board. I also tweaked the output of the subs until the intensity of the LF matched the intensity of the 12” woofer of the LB12. The additional low frequency response undergirded the LB12 and made it seem weightier. If the LB12 is to be used in an HT setting, I strongly recommend the addition of subwoofers. Do not be put off from adding subwoofers if they cost double or more the MSRP of the LB12. Pairing inexpensive and poorly measuring subwoofers will muddy the performance and a great deal of the beauty of the Nostala will be occluded.

 

First run with the Faux Mono Integrated Amplifier configuration

The Faux Mono Integrated configuration is special, the equivalent of audio Kryptonite. It brings otherworldly powers to an audio system, and for a relative pittance. I describe it in detail in my book, The Audiophile Laws. I encourage those who want to learn practical principles for efficient advancement of their system to consult the website, theaudiophilelaws.com. The Faux Mono Integrated configuration is suitable for speakers which are bi-wirable, having two sets of binding posts, for bass and for mid/treble.

My first system with the LB12 featured a new, electrifying upgrade, a 12v 100Ah Lithium battery, because I have transitioned to powering my front end off grid! I cannot overstate the positive influence that has resulted by putting the PS Audio AirLens, TEAC VRDS-701 CD/DAC/Preamp and TEAC CG-10M-X Clock all on battery power. The setup is simple; 12v lithium battery to Victron Phoenix 12/250 Inverter, to component(s). I am using a NOCO Genius 10 charger to keep the battery charged.

An easily identifiable snapping into focus occurred with each component placed on battery to AC power. The experience reminds me of when I have my eyes checked by an optometrist who spins the lenses to find the prescription for glasses. “A or B, A or B”, the refrain goes. If A represents wall power, then the answer is simple, always B, for battery power! I intend on adding a segment in the second edition of The Audiophile Laws discussing this system configuration method.

The re-clocked digital coaxial (SPDIF) signal output from the TEAC VRDS-701 was then split using a generic Amazon optical (Toslink) Y-cable and outfitted with two Audioquest Coffee Digital Cables (Toslink). These were run to the optical inputs of a pair of PS Audio Stellar Strata Mk2 Integrated Amplifiers, wired in a horizontal bi-amp configuration. The horizontal biamping dedicates one integrated amp for bass of both speakers and the other for midrange/treble of both speakers. In that way minor, i.e., one detent or digital number of the display, adjustments allow for tonal rebalancing of the system with zero sonic penalty! It is a terrifically powerful method that I find compelling versus even far more expensive traditional systems.

Further, I applied one of my Audiophile Laws regarding cables to elicit the utmost performance from the LB12 by using parallel (double) speaker cables.  In that way the AWG is lowered, the capacitance is doubled and the resistance halved. The outcome is easily discernible sound quality improvement across the board. Further, I paired a blend of the Iconoclast Generation 2 TPC (red jacket) and Generation 2 SPTPC (blue jacket) Speaker cables rather than isolating them. Blending the speaker cables with each cable’s distinct conductor brings the best sound I have achieved with Iconoclast’s speaker cables.

In other words, the Nostala was given some of the best system building advantages I have developed, and it sounded like it! It responded eagerly to every advantage I developed and frankly, performs on a level that is unnerving to someone who has used a lot of speakers in the $30-40K range (but remember, the Perlisten subs were also in the system)!

 

Grounded

The Nostala is intended for placement on the floor, but the low positioning presents an issue for me. A speaker that rests on the floor and fires upward is fundamentally less impressive in terms of scale of the music than one having the midrange and treble driver placed higher. It is not only the size and configuration of drivers that contributes to the sense of scale, but also the height from which the sound emanates. It is easy enough to demonstrate by placing a pair of smallish bookshelf speakers on the floor or low stands, then raising them up on higher stands. When a speaker’s midrange and treble drivers sit higher up, the entire soundstage is shifted such that it sounds like the performance is larger.

There are many considerations that go into the decision of what angle to make a speaker’s front baffle slope. Most tower speakers have no baffle slope, and any variance is left up to the owner to adjust the spikes or footers. Floor hugging speakers like the Nostala require a backward cant, or else they would sound miserable, as though the sound is being driven into the floor. While I find the native angle of the baffle of the LB12 to be acceptable, to my ear it is not optimal, as it does not lift the soundstage to a height that signals a large enough scale to satisfy me. When I hear the Nostala resting on its rails, I hear a soundstage in which the acoustic energy largely lingers in the lower half of the room and does not recreate the illusion of formidableness cast by taller floor standing speakers. The LB12 has the driver complement to give a more formidable performance than when it sits on the floor but is constrained by being grounded.

There is a solution to ameliorate, but not eliminate entirely, this condition and it is found in placing hard rubber hockey pucks under the front rails! Before I began using the PureAudioProject Trio15 Speakers in a lofted Landscape Orientation (I have reviewed several iterations, and currently use the 10” Coaxial, my favorite), I removed the front spikes and placed hockey pucks under the front of the speaker’s frame to dramatically tilt the baffle backwards, thus raising the soundstage. I did the same with the LB12 when I placed the hockey pucks under its front footer rail, and it has several benefits. As expected, it lifts the soundstage to mimic a much larger speaker. It also cleans up the bass by lessening floor bounce and directing the woofer towards the listener’s ear while aiming the midrange on the same plane as my ear. The midrange becomes the focus, not the tweeter, and the succulent mid frequencies are more evident. These benefits combined to yield a more tight, coherent sounding speaker, and one with a larger sense of scale to the soundstage.

Conversely, some enormous speakers, such as the Kingsound King III or the Legacy Audio Whisper project a great deal of their wave launch over the listener’s head to the degree that the optimal focusing of the speaker’s output is too high! With those speakers, I use approximately .25” drink coasters under the rear footers (or in the case of the Whisper, the wooden apron of the speaker) to tilt the front baffle slightly downward toward the listening seat. The tightening and intensifying of the soundstage is remarkable!

A word of caution about physically altering a speaker’s baffle slope, either forward or backward. The mass of a speaker shifts when tilted forward or backward physically, and care must be taken that it does not become unstable! Use of a hard rubber hockey puck can shift a shorter or thinner speaker’s center of gravity off center to a high degree. I would not use this method if the speaker was in an environment with smaller children or where there is foot traffic or visitors to the room. Altering the center of gravity of any speaker physically is a do at your own risk activity and safety is a higher priority than shifting the soundstage.

 

Flying         

One of my primordial thoughts about the LB12, was that I would put them on speaker stands. They would look absurdly large, but who cares? The humongous stand-mounted Dutch & Dutch 15c was shown in the lobby of the Renaissance Schaumburg Hotel & Convention Center, the venue of AXPONA 2026. Though it looked absurdly large for a stand mounted speaker, most thought it was cool and good sounding.

In addition, I have turned the LB12 and placed them on their sides to create a Landscape Orientation soundstage! With the offset midrange and tweeter, there are two distinct options, with those drivers oriented to the inside or to the outside of the woofers. I oriented them to the inside of the woofers and will likely will not use them with the midrange and tweeter placed to the outside because it would drop the height of those drivers below the seated listener’s ears. It also would stretch the center image to an extreme. With smaller speakers that I have tried in Landscape Orientation with the mid/tweeter to the outside, I have always reverted to inside placement. Note my 24” stands are sand filled and weigh perhaps half the speaker’s weight. I do not recommend putting the Nostala LB12 atop flimsy stands! This is a do-at-your-own-risk activity!

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Popups Powered By : XYZScripts.com